Large Boom Arm Instruction Sheet
1.Take the three casters out of package. When taking out caster spacers will be included.

2.Open the 13’ HD stand. At the end of each leg is a hole. Line up the nipple on the spacers, with the hole.

3. On the caster unscrew the knob. At the end of the leg on the stand, slide the caster over the spacer, tighten the knob: do the same on all three casters.

4. Mounting bracket: There are two knobs with the mounting bracket. On the back of the bracket there are two tabs that say PULL, pull off tabs and screw the two knobs to the bracket. With the two knobs in place, put mounting bracket on top of your 13’ HD stand, tighten knob to the stand.

5. locate the silver “top” to the stand”: This “top” attaches to your light. Take”the top” slide into the end of the pole, with the knob attached, tighten down knob.

6. There are 2 boom arm parts: Take the two parts and line them up. Line up the hex screw on one end of the pole with the holes. After the two ends are together, use the allen key to tighten down the hex screw.

7. On the stand, loosen the top knob on mounting bracket. Slide the pole into the boom arm mounting bracket. Slide the arm about half way down the mounting bracket, tighten knob on the mounting bracket.


8. Last is the counterweight, the parts included are:
1 knob, 1 black washer, 1 black backing plate &1 spring. Take the black washer and slide it on the knob, place the backing plate on, then the spring . Tighten knob snug, but not all the way, on the top of the counterweight.

9. Now slide on counterweight tighten knob.

NOTE: Before placing any SOFFBOX or LIGHTS on stand MAKE SURE ALL KNOBS ARE TIGHTEN DOWN!!!!!!