Instructions for Soff Strip RS
1. Place fabric on flat surface with silver side up.
2. Position strobe connector backplate face down. inserting each of the four corner hub pins into the four Grommet holes in the fabric. Be sure the backplate is positioned correctly so that when the rods are inserted into the corner hubs, they will be going in the right direction.
3. Insert ONE rod at a time into the corner hubs, and pull the corresponding grommeted fabric up and over the rod tip pin. REMEMBER! Assemble only one rod into corner hub and fabric attachment at a time. NOTE: Some of the Soff Strip RS rods have bends in them. Make sure they are inserted into the corner hub so that the rod extends to an upward position. (channel side of the rod always faces fabric).
4. Pull the grommeted fabric, one corner at a time, up and over the rod tip pin. Your Soff Strip RS will form its shape. IMPORTANT! Sometimes a grommet will slip off a back plate corner hub pin, this will cause your fabric to "hang-up" making it difficult to pull the fabric to the rod tip. Double check these points during assembly.
5. Inside baffle: If you wish to use it, attach to corresponding velcro.
6. Attach your strobe head to a light stand and connect your Soff Strip RS to it. Some prefer the reverse: connect your strobe head to your Soff Strip RS first, then attach to a light stand.
NOTE: If your SOFF STRIP is "lopsided" it is because one or more of the rods are not fully inserted (seated) into the corner hubs.

Click here for pdf