Soff Box RS Instructions
1. Place fabric on flat surface with silver side up.
2. Position strobe connector (spin ring backplate) face down, so that your connector will be outside your Soff Box RS.
3. Insert each of the four backplate pins into the four grommet holes in the fabric.
4. Insert one rod at a time into the corner hubs, and pull the corresponding grommeted fabric up and over to the rod pin. REMEMBER! Assemble only one rod into corner hub and fabric attachment at a time. NOTE: some of the Soff Box RS rods have bends in them. Make sure they are inserted into the corner hub so that the rod extends to an upward position. (channel side of the rod always faces up)
5. IMPORTANT! Sometimes a grommet will slip off a backplate corner hub pin, this will cause your fabric to "hang-up" making it difficult to pull the fabric to the rod tip. DOUBLE check these points during assembly.
6. Inside baffle: if you wish to use it, attach to corresponding velcro.
7. Attach your strobe head to a light stand and connect your Soff Box RS to it. Some prefer the reverse: connect your strobe head to your Soff Box RS first, then to a light stand.
NOTE: if your Soff Box is "lopsided" it is because one or more of the rods are not fully inserted (seated) into the corner hubs.

Click here for pdf